7. To measure the resistance of an alarm circuit the technician needs a(n)
a. manometer.
b. multi meter.
c. amp meter.
d. oscilloscope.
8. 2-wire residential smoke detectors must be wired with
a. end-of-line resistors and a power supervision module.
b. 18-gauge wire.
c. an end-of-line resistor.
d. a specific internal zone address.
9. To increase standby time for a 12-volt burglar alarm system the technician should
a. connect batteries in series.
b. use a larger battery charger.
c. connect batteries in parallel.
d. use a larger transformer.
10. Burglar alarm installations are regulated by
a. NFPA 101
b. UL 827
c. NFPA 731
d. NFPA 70
11. Certifications for burglar alarm technicians include
a. ESA
b. NICET
c. ASIS
d. NFPA
12. Motion detectors without a tamper switch may not be used on a commercial installation because they are not UL-listed.
a. True
b. False
13. New communication methods allow burglar alarm panels to use integrated IP technology to report to a monitoring station.
a. True
b. False
14. The person or entity who approves an alarm installation may be
a. the owner.
b. the local building official.
c. the insurance agent.
d. any of the above
15. The sum of the value of resistors connected together end-to-end is lower than the lowest resistor in the chain.
a. True
b. False